This could be down to something like there has been a new member of staff recruited (increasing the potential appointments available), or appointment times have been shortened (meaning that more appointments can be booked in the same period). This indicates that there has been a change in the process- such as there are more appointment slots available than what there was previously (this would reduce the waiting times). A trend would indicate that there has been a change in process resulting in a change in outcome.Įg, on an SPC chart showing patient waiting times there may be a run of 7 points below the mean. A Trend- a trend may be identified where there are 7 consecutive points in either a pattern that could be a downward trend, and upward trend, or string of data points that are all above, or all below the mean.These are very unlikely to occur- and where they do, there is likely a reason or handful of reasons outside the control of the process behind the extreme value.Extreme values- (special cause) any value on the line graph that falls outside the control limits.Normal variation- (common cause) fluctuations in data points that sit between the upper and lower control limits that do not reach the criteria for a Trend.Normal variations in performance across time can occur randomly- without a direct cause, and should not be treated as a concern, or a sign of improvement, and is unlikely to require investigation unless one of the patterns defined below applies. Any target set that is not within the control limits will not be reached without dramatic changes to the process involved in reaching the outcomes. In order for this target to be achievable, it should sit within the control limits. Any data points on the line graph outside these limits, are ‘extreme values’ and is not within the expected ‘normal variation’. Two horizontal lines either side of the Mean- called the upper and lower control limits.This is used in determining if there is a statistically significant trend or pattern. This is the sum of the outcomes, divided by the amount of values.
The data can be in months, weeks, or days- but it is always best to ensure there are at least 15 data points in order to ensure the accurate identification of patterns, trends, anomalies (causes for concern) and random variations.Ī horizontal line showing the Mean. The charts consist of.Ī line graph showing the data across a time series. SPC charts help to overcome the limitations of RAG ratings, through using statistics to identify patterns and anomalies, distinguishing changes worth investigating (Extreme values) from normal variations. SPC charts (Statistical Process Control Charts) are used to measure changes in data over time.
0 kommentar(er)
